Editing Installing an oil pressure/temperature gauge in S2 (section)

===Testing, calibrating and setting of warning levels===
To follow, including video of gauge in motion.


Setting the warning levels is as per the instructions included with the gauges, recorded here for reference when I inevitably lose the instructions.

1. Mute selecter: Set key hold after power on

2. Peak selecter: 
      [To View] Normal mode --> SET KEY --> Peak mode --> SET KEY --> Normal mode
      [To Reset] Normal mode --> SET KEY --> Peak mode --> HOLD SET KEY 3 SEC --> Clear peak --> PEAK LED FLASH --> Normal mode

3. Warning set selecter:
      [Slow] Normal mode --> HOLD SET KEY 5 SEC --> Warning set mode / pointer LED flash --> SET KEY --> Pointer move slowly --> OVER 5 SEC --> Normal mode
      [Quick] Normal mode --> HOLD SET KEY 5 SEC --> Warning set mode / pointer LED flash --> HOLD SET KEY --> Pointer move quickly --> OVER 5 SEC --> Normal mode


No calibration necessary

S2 135R with PRRT fitted reads:
      - ~6 bar from cold (ambient temp 20C / June / summer time)
      - 5 bar when warm and driving to red line / limiter
      - 4.5 bar when driving at easy pace
      - 1.8 bar idle at warm

      - 100C motorway / enthusiastic A/B-road driving
      - 90C easy pace driving
      - 120C+ on track


Note: Temperature warning level is a HIGH value (e.g. 110C), pressure warning is a LOW value (e.g. 1 bar)

[[Category:DIY]]
[[Category:Lotus Elise]]
[[Category:Interior]]
[[Category:S2 Exige]]
[[Category:S2]]