Editing CAN bus Mapping (section)

== iPhone display project ==

An ESP32-C3 sends decoded data over BLE to an iPhone application. The iPhone app was at '''version 1.1''' during this work; the ESP32 firmware has an independent version history.

{| class="wikitable"
! Information !! Status
|-
| Steering angle || Confirmed CAN signal
|-
| Accelerator input || Confirmed CAN signal
|-
| Clutch and brake switches || Confirmed CAN signals
|-
| Normal / Sport / Race mode || Identified and displayed by app
|-
| Engine RPM || Display/calibration tested
|-
| Coolant temperature || Temperature observations recorded; byte map provisional
|-
| Fuel level || Provisional decoding
|-
| Vehicle speed / wheel speeds || Reference mapping, road validation pending
|-
| Calculated gear || Bench tested, road validation pending
|-
| Yaw/lateral acceleration || Candidate signal
|-
| Exhaust valve state || Not yet identified
|-
| TPMS values || Not yet identified on the CAN bus
|}