Editing Evora front bumper removal (section)

==Headlight Removal==

Undo the two button head screws holding the headlight to the bracket

[[image:Evora-Bumper-Removal-13.jpg|400px]]

Right down at the front (this is a bit of a stretch) loosen the 3rd headlight fixing screw - it does not need to be removed, just loose.

There is a slot in the mounting bracket that will allow the screw to slide out. - note any shims that might be present.

Here you can see what the bracket will look like (top left) just to give you an idea.

[[image:Evora-Bumper-Removal-14.jpg|400px]]

Remove the headlight support bracket (That rusty nut and it's mate to the right)

[[image:Evora-Bumper-Removal-15.jpg|400px]]

Unclip the washer hose from the headlight by pressing this square button and then sliding off.

[[image:Evora-Bumper-Removal-16.jpg|400px]]

The headlight can now be withdrawn through the wheel arch.
Repeat for other side.

Remove these 4 screws noting how many shims are on the bracket stalk.

[[image:Evora-Bumper-Removal-17.jpg|400px]]

[[image:Evora-Bumper-Removal-18.jpg|400px]]

At the front of the clam, remove these two screws inside the front clam edge - there are 2 each end - use an offset ring spanner - works a treat.

An alternative is a tiny 1/4 ratchet with a shallow socket.

[[image:Evora-Bumper-Removal-19.jpg|400px]]

Pull out the packing foam between the wheel arch and the chassis, then remove the 3 screws holding the clam to the A-post / chassis (note the shim qty and location on each of the 2 A-Post fasteners)

[[image:Evora-Bumper-Removal-20.jpg|400px]]

Unclip and disconnect the side repeater connector.

Repeat for other side.