Editing Fit a PRRT (section)

===Refitting===

The original jubilee clips can be used to secure the new setup to the car, leaving the remaining clip (originally there were 2 on the top return hose) to secure hose H to pipe 1.

If a drain take off is present, all clips could be tightened, otherwise leave the bottom pipe disconnected to allow system flushing. Personally, I recommend a good and repeated flush of the whole coolant system with clean water, especially if a different type of coolant is going to be used. Refill the circuit with coolant, check all the junctions for leaks and bleed the system as on the Service Manual.

*Below there are some photos of the PRRT fitted to my car. 

<gallery>
Image:ThermoF.jpg|Click to Enlarge

Image:ThermoG.jpg|Click to Enlarge

Image:ThermoH.jpg|Click to Enlarge

Image:ThermoL.jpg|Click to Enlarge
</gallery>