Editing Installing an oil pressure/temperature gauge in S2 (section)

===Laying cables===
The cables that come with the sensors are obviously not intended for a mid engine car as they turned out to be too short. I had to cut them and solder in another 50 cm of cable. From the sensors the cables were fed through the same chassis hole that has the throttle cable. 

[[Image:Oil-004.jpg]]

Inside the passenger compartment the cables were fed through the center console and follows other cables into the dashboard. This was probably the hardest part. You need to be a contortionist to handle anything there. My wife managed to get the tie-raps on, amazing.

[[Image:Oil-005.jpg]]